G3 Dome camera disconnects from Protect after ~15min

Installed a G3 Dome connected to US-24-250W switch. The camera repeatedly shows disconnected. A power cycle of the POE port returns the camera to service only to have it disconnect again. Switch shows the port pulling power (3.2 - 3.7W).

Protect 1.17.4 running on CK 2+. Camera firmware 4.34.22

Thoughts?

submitted by /u/waller476tree
[link] [comments]

Read more here: https://www.reddit.com/r/UNIFI/comments/n53obn/g3_dome_camera_disconnects_from_protect_after/

Content Attribution

This content was originally published by /u/waller476tree at Let's talk about things., and is syndicated here via their RSS feed. You can read the original post over there.

%d bloggers like this: